KIA Niro: Replacing glove box lamp (Bulb type)

KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual / Maintenance / Lamps / Replacing glove box lamp (Bulb type)

Replacing glove box lamp (Bulb type)

Operation

  1. Using a flat-blade screwdriver, gently pry the lamp assembly from interior.
  2.  Remove the cover from the lamp assembly.
  3. Remove the bulb by pulling it straight out.
  4. Install a new bulb in the socket.
  5. Install the cover to the lamp assembly.
  6. Install the lamp assembly to interior.

WARNING

Prior to working on the Interior lamps, ensure that the "OFF" button is depressed to avoid burning your fingers or receiving an electric shock.

Replacing luggage lamp (Bulb type)

Replacing luggage lamp (Bulb type)

Operation

  1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing.
  2. Remove the bulb by pulling it straight out.
  3. Install a new bulb in the socket.
  4. Align the lens cover tabs with the lamp housing notches and snap the lens into place.

WARNING

Prior to working on the Interior lamps, ensure that the "OFF" button is depressed to avoid burning your fingers or receiving an electric shock.

    READ NEXT:

     Headlamp and front fog lamp aiming (for Europe)

    Headlamp aiming Type A Type B Operation Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools. The vehicle should be placed on a flat floor. Draw vertical lin

     Appearance care

     Exterior care

    Exterior general caution It is very important to follow the label directions when using any chemical cleaner or polish. Read all warning and caution statements that appear on the label. NOTICE If you park the vehicle around a stainless signbo

    SEE MORE:

     Steering Gear box Repair procedures

    Removal Disconnect the battery negative cable. Remove the universal bolt (A). Tightening torque : 32.4 - 37.3 N*m (3.3 - 3.8 kgf*m, 23.9 - 27.5 lb*ft) Warning Keep neutral range to prevent damaging the clock spring inner cable w

     Electric parking brake control

    Electric parking brake control module EPB switch EPB actuator Removal and Installation EPB Actuator Turn ignition switch off and disconnect the battery (-) cable from the battery. Remove the rear caliper. (Refer to Brake Sys

    Categories

    2022-2025 © - www.infoniro.com | Policy