KIA Niro: Removal

Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transponder key ECU assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedures

Effects / Inoperative when not performed

Link

Disconnect cable from negative battery terminal

Initialize back door lock

Power door lock control system

Memorize steering angle neutral point

Lane departure alert system (w/ Steering Control)

Pre-collision system

Transponder key ECU assembly

Perform code registration (Immobiliser system)

Engine starting

w/o Smart Key System:

PROCEDURE

1. REMOVE AIR CONDITIONER UNIT ASSEMBLY (for Cold Area Specification Vehicles)

Click here

2. REMOVE AIR CONDITIONER UNIT ASSEMBLY (except Cold Area Specification Vehicles)

Click here

3. REMOVE TRANSPONDER KEY ECU ASSEMBLY

(a) Disengage the guides to remove the transponder key ECU assembly as shown in the illustration.

Remove in this Direction (1)

Remove in this Direction (2)

    READ NEXT:

     KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual

    An electric vehicle is driven using a battery and an electric motor. While general vehicles use an internal combustion engine and gasoline as fuel, electric vehicles use electrical energy that is charged & stored inside the high voltage battery.

     Electric vehicle guide (Kia Niro EV)

     Review of electric vehicle

    An electric vehicle is driven using a battery and an electric motor. While general vehicles use an internal combustion engine and gasoline as fuel, electric vehicles use electrical energy that is charged & stored inside the high voltage bat

    SEE MORE:

     Opening the hood

    (Kia Niro Hybrid only) Hood release lever Hood secondary latch Hood Operation Pull the hood release lever (1).  Push the secondary latch (2) to the left. Lift the hood (3) upwards. Go to the front of the vehicle, raise

     Normal maintenance schedule - for Australia and New Zealand

    The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty. Where both mileage and time are shown, the frequency of service is d

    Categories