KIA Niro: Drive Belt System

Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual / Engine Mechanical System / Drive Belt System

Drive Belt / Idler Repair procedures

Drive Belt Repair procedures Removal Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") Remove the drive belt. (1) Using the wrench, turning the mechanical tensioner (A) co

Drive Belt Tensioner Repair procedures

Removal and Installation Remove the drive belt. (Refer to Drive Belt System - "Drive Belt") Remove the mechanical tensioner (A). Tightening torque : 18.6 - 23.5 N*m (1.9 - 2.4 kgf*m, 13.7 - 17.4 lb*ft) Remove the hydr

Engine And Transaxle Assembly

Engine Room Under Cover Repair procedures Removal Engine room under cover. Remove the engine room under cover (A). Tightening torque : 3.9 - 5.9 N*m (0.4 - 0.6 kgf*m, 2.9 - 4.3 lb*ft) Install in the reverse order of removal.

SEE MORE:

Crankcase Emission Control System

Schematic Diagram Repair procedures Inspection After disconnecting the vapor hose from the PCV valve, remove the PCV valve. Reconnect the PCV valve to the vapor hose. Run the engine at idle, then put a finger over the open end of the

Front Door Module | Front Door Outside Handle

Front Door Module Components and components location Front door module Replacement Remove the front door trim. (Refer to Front Door - "Front Door Trim") Disconnect the front door main connector (A).