KIA Niro: Wipers (Kia Niro EV)

KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual / Features of your vehicle / Wipers and washers / Wipers (Kia Niro EV)

Controlling the wipers

Type A
Type A

Type B
Type B

Type C
Type C

Operation

  1. A: Front wiper speed control
  • MIST (1x): Single wipe
  • OFF (0): Off
  • INT (---): Intermittent control wipe

AUTO*: Auto control wipe

  • LO (1): Low wiper speed
  • HI (2): High wiper speed
  1. B: Intermittent control wipe time adjustment/Auto control wipe time adjustment*
  2. C: Wash with brief wipes

Controlling the wipers automatically

Type A
Type A

Type B
Type B

Type C
Type C

  1. Rain sensor (if equipped)
  2. Wiper speed control switch

Operation

  • The rain sensor (A) senses the amount of rainfall and adjusts the wiper speed interval accordingly.
  • Turn the speed control switch (B) to adjust the wiper speed

    READ NEXT:

     Washers (Kia NIRO Hybrid)

    Controlling washers Type A Type B Type C Operation Move the wiper speed control switch to / position. Pull/push the lever to spray washer fluid on the windshield. The wipers run several times. WARNING Do not use the washe

     Washers (Kia Niro EV)

    Controlling the washers Type A Type B Type C Operation Move the wiper speed control switch to OFF (0) position. Pull the lever gently toward you to spray washer fluid on the windshield. Operate the wipers so they perform sever

     Welcome system

    The surroundings or the interior will be appeared when the driver approaches or exits the vehicle. Illuminating functions Door handle lamp Operation Door handle lamp will turn on for approximately 15 seconds. Operating condition(s)

    SEE MORE:

     Direct Oncoming function (if equipped) Kia Niro EV

    Warning and control The Direct Oncoming function is warned and controlled by the following level. Collision warning Emergency braking Stopping vehicle and ending brake control Collision warning A: Collision Warning! The warning mes

     Electrical Circuit Inspection Procedure

    Check Open Circuit Procedures for Open Circuit Continuity Check Voltage Check If an open circuit occurs (as seen in (FIG. 1)), it can be found by performing Step 2 (Continuity Check Method) or Step 3 (Voltage Check Method) as s

    Categories

    2022-2025 © - www.infoniro.com | Policy