KIA Niro: Basic Troubleshooting

Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual / Hybrid Control System / Basic Troubleshooting

Basic Inspection Procedure

Measuring Condition of Electronic Parts' Resistance The measured resistance at high temperature after vehicle running may be high or low. So all resistance must be measured at ambient temperature (20ÂºC, 68ÂºF), unless stated otherwise.

Connector Inspection Procedure

Handling of Connector a. Never pull on the wiring harness when disconnecting connectors. b. When removing the connector with a lock, press or pull locking lever. c. Listen for a click when locking connectors. This sound indicates that

Electrical Circuit Inspection Procedure

Check Open Circuit Procedures for Open Circuit Continuity Check Voltage Check If an open circuit occurs (as seen in (FIG. 1)), it can be found by performing Step 2 (Continuity Check Method) or Step 3 (Voltage Check Method) as s

SEE MORE:

Power Door Lock Module Repair procedures

Inspection Warning When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. When removing the interior trim pieces, use a plastic panel removal tool not to damage the

Fly Wheel Repair procedures

Components Water jacket insert Cylinder block Oil ring Rear oil seal Crankshaft upper bearing Thrust bearing Crankshaft Pilot bearing Crankshaft lower bearing Crankshaft lower bearing cap Ladder frame Piston ring Pisto