KIA Niro: Cylinder Block
READ NEXT:
Fly Wheel Repair procedures
Components
Water jacket insert
Cylinder block
Oil ring
Rear oil seal
Crankshaft upper bearing
Thrust bearing
Crankshaft
Pilot bearing
Crankshaft lower bearing
Crankshaft lower bearing cap
Ladder frame
Piston ring
Pisto
Rear Oil Seal Repair procedures
Replacement
Warning
Be sure to read and follow the "General Safety Information and
Caution" before doing any
work related with the high voltage system. Failure to follow the safety
instructions may result in
serious electrical injuries
Piston and Connecting Rod Repair procedures
Disassembly
Warning
Be sure to read and follow the "General Safety Information and
Caution" before doing any work related
with the high voltage system. Failure to follow the safety instructions may
result in serious electrical
injuries
SEE MORE:
Inverter kit / Body kit
Remove the battery (-) cable.
Disconnect the high voltage circuit. (Refer to Generals)
Use the recovery/reproduction/charging device to recover the coolant.
Warning
When removing the connector between the vehicle and the
compressor,
Engine Oil Level
Warning
Be sure that the vehicle is on level ground.
Warm up and stop the engine, and then wait for 5 minutes.
Turn the engine off and wait for a few minutes (about 5 minutes) for the
oil to return to the oil pan.
Pull the dipstick out, w
Categories
- Home
- KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual
- Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual
- Contact Us
