KIA Niro: Hybrid Electric Vehicle (HEV)

Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual / Service Highlight / Hybrid Electric Vehicle (HEV)

Hybrid Control System / Description And Operation

The Hybrid Electric Vehicle (HEV) uses hybrid power source (Engine, Electric motor), so its fuel efficiency is relatively high and exhaust emission is very small compared to the traditional vehicle which uses only engine as power source. It con

Hybrid Control System / Components And Components Location

HPCU (Hybrid Power Control Unit) On-Board Charger (OBC) Charge Port Power Cable (HPCUâ†”HSG,Electronic A/C Compressor) Power Cable (HPCUâ†”Main High Voltage Battery System) Power Cable (Main High Voltage Battery System â

Hybrid Power Control Unit (HPCU) connector and high voltage cable

Hybrid Power Control Unit (HPCU) terminal And Input/Output signal HPCU Terminal Function Connector (C133-S) (94Pin) : HPCU signal input and control High Voltage Cable (C133-P) (2 Pin) : HPCUâ†”Power Relay Assembly

SEE MORE:

Decreasing set speed

Push the (-) switch down and release it immediately. The set speed will decrease by 1 km/h (1 mph) each time the switch is operated in this manner. Push the (-) switch down and hold it. The set speed will decrease by 10 km/ h (5 m

Rear Lower and Upper Arm Repair procedures

Removal Disconnect the battery negative cable. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N*m (11.0 - 13.0 kgf*m, 79.6 - 94.0 lb*ft) Warning Be careful not to damage the wheel nuts when removing the wheel and tire