KIA Niro: Keyless Entry And Burglar Alarm

Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual / Body Electrical System / Keyless Entry And Burglar Alarm

Keyless Entry And Burglar Alarm / Description And Operation

Keyless Entry And Burglar Alarm / Components And Components Location Specification Hood switch Horn (High-pitch) Horn (Low-pitch) Body control module (BCM) Door lock/unlock buzzer Front door actuator & switch Rear door ac

Keyless Entry And Burglar Alarm / Repair Procedures

Inspection Warning When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. When removing the interior trim pieces, use a plastic panel removal tool not to damage the

Lighting System

Lighting System / Components And Components Location Specifications Lighting System / Components And Components Location Headlamp (Low/High BI-Function) Turn signal lamp Sub low beam Daytime running light, Position lamp Fog

SEE MORE:

ETC (Electronic Throttle Control) System Repair

Inspection Connect the KDS on the Data Link Connector (DLC). Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle Position Sensor (TPS) ETC Motor Switch "OFF" the ignition. Discon

Reservoir Repair procedures

Removal Turn the ignition switch OFF and disconnect the battery (-) terminal. Drain the hydraulic oil from the reservoir using a syringe. Loosen the reservoir hose (A) and bolts (B) and then remove the reservoir. Tightening torque : 3.