KIA Niro: Replacing the front wiper blade (Kia Niro EV)

KIA Niro EV / Hybrid (SG2) - (2021-2023) - Owner's manual / Maintenance / Wiper blade / Replacing the front wiper blade (Kia Niro EV)

Replacing the front wiper blade (Kia Niro EV)

Operation

  1. Turn off the vehicle.
  2. Move the wiper switch to the single wiping (MIST/1x) position within 20 seconds.
  3. Hold the wiper switch for more than 2 seconds.
  4. Raise the wiper arm.
  5. Lift the wiper blade clip up (1). Pull down the blade assembly and remove it (2).

Replacing the front wiper blade (Kia Niro EV)

  1. Install the new blade assembly.

Replacing the front wiper blade (Kia Niro EV)

  1. Upon starting the vehicle, the wiper arms will return to their normal operating position.

    READ NEXT:

     Replacing rear wiper blade  Kia Niro EV /  Hybrid

    Replacing rear wiper blade Operation Turn off the vehicle. Move the wiper switch to the single wiping (MIST/1x) position. Hold the wiper switch for more than 2 seconds. Raise the wiper arm and pull out the wiper blade assembly.

     Battery

     Battery (Plug-in hybrid)

    For best battery service * The battery is located in the right side of the luggage room. Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum

    SEE MORE:

     Hybrid Power Control Unit (HPCU) connector and high voltage cable

    Hybrid Power Control Unit (HPCU) terminal And Input/Output signal HPCU Terminal Function Connector (C133-S) (94Pin) : HPCU signal input and control High Voltage Cable (C133-P) (2 Pin) : HPCU↔Power Relay Assembly

     Blind-Spot Collision-Avoidance Assist operation

    Blind-Spot Collision-Avoidance Assist will warn and control as following operation. Vehicle detection Collision warning Collision-avoidance assist (while departing) Vehicle detection The warning light on the outside rear view