KIA Niro: Sunroof
READ NEXT:
Sunroof / Repair Procedures
Adjustment
Inspect Glass Alignment
Inspect the step height between the roof panel (A) and the glass
weatherstrip (B) and then adjust it if
necessary.
Alignment adjustment
Standard value (mm(in.))
(1) Front edge : 0 mm (0 in.)
(2) Rear
Sunroof Assembly | Sunroof Sunshade
Sunroof Assembly
Replacement
Warning
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on glove to protect your hands.
Remove the roof
SEE MORE:
AHB Brake System Bleeding procedure
The iBAU consists of 3 brake fluid lines in total (Low/high pressure and
pedal simulator lines), therefore, air bleeding should be made
sequentially following the procedure below.
Bleeding sequence : Low pressure/Pedal simulator section (
Electric parking brake control
Electric parking brake control module
EPB switch
EPB actuator
Removal and Installation
EPB Actuator
Turn ignition switch off and disconnect the battery (-) cable from the
battery.
Remove the rear caliper.
(Refer to Brake Sys
Categories
- Home
- KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual
- Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual
- Contact Us
