KIA Niro: Adjusting the front seat

Operation

The seat can be adjusted by using the control levers located on the outside of the seat cushion.

INFORMATION

Adjust the seat before driving, and make sure the seat is locked securely by trying to move without using the lever. If the seat moves, it is not locked properly.

Manual seat

Manual seat

  1. Forward/backward
  2. Seatback angle
  3. Seat height

Power seat (if equipped)

Power seat (if equipped)

  1. Forward/backward
  2. Seatback angle
  3. Seat height
  4. Cushion tilt

Lumbar support (if equipped)

Lumbar support (if equipped)

  1. Increase support
  2. Decrease support

NOTICE

(Kia Niro EV only)

Do not continue to operate the lumbar support when the lumbar support provides its maximum support. Damage to the lumbar support motor could occur.

    READ NEXT:

     Relaxion comfort seat (for passenger's seat) (Kia NIRO Hybrid)

    Relaxion comfort seats distribute body pressure and concentrated weight on specific body parts that occur while sitting in the same position for a long period of time. The seat relieves fatigue and discomfort by providing the optimal sit po

     Seatback pocket

    Seatback pocket USB charger WARNING Loose objects in the driver's foot area could interfere with the operation of the foot pedals, possibly causing an accident. When you return the seatback to its upright position, hold

     Unfolding rear seatback (Kia NIRO Hybrid)

    While pulling on the seatback folding lever, lift and pull the seatback backward. Pull the seatback firmly until it clicks into place. Return the rear seat belt to the proper position If you want to tilt the rear seatback a bit m

    SEE MORE:

     Energy flow

    The hybrid system informs the drivers its energy flow in various operating modes. While driving, the current energy flow is specified in 11 modes. Vehicle stop A: Idle Mode The vehicle is stopped. (No energy flow) EV propulsion A:

     Front Door Latch

    Front door latch Replacement Remove the front door module. (Refer to Front Door - "Front Door Module") Disconnect the front door latch rod (A) and extension wiring clip (B). Remove the front door latch (B) after

    Categories