KIA Niro: Front Driveshaft

Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual / Driveshaft and axle / Front Driveshaft

Front Driveshaft Repair procedures

Component location Inner shaft bearing bracket Drive shaft (RH) Drive shasft (LH) Front Driveshaft Repair procedures Removal Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N*m (11.0 - 13.0 kgf*m, 79.6 - 94.0 lb*ft

TJ Joint Repair procedures

Removal Warning Drive shaft joints require special grease, so do not add any other type of grease. When replacing the boot band, it must be a new one. Remove the front drive shaft. (Refer to Driveshaft Assembly - "Front Drive

Driveshaft Assembly

Removal The type can replace the wheel side joint boot Remove the front driveshaft. (Refer to Driveshaft Assembly - "Front driveshaft") Remove the transaxle side joint. (Refer to Driveshaft Assembly - "Joint Assembly(Tra

SEE MORE:

Sunroof / Repair Procedures

Adjustment Inspect Glass Alignment Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary. Alignment adjustment Standard value (mm(in.)) (1) Front edge : 0 mm (0 in.) (2) Rear

Rear Oil Seal Repair procedures

Replacement Warning Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries