KIA Niro: Hybrid Electric Vehicle (HEV)
Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual / Hybrid Control System / Hybrid Electric Vehicle (HEV)
- Hybrid Control System / Description And Operation
- Hybrid Control System / Components And Components Location
- Hybrid Power Control Unit (HPCU) connector and high voltage cable
- Hybrid Power Control Unit (HPCU)/ Repair procedures
READ NEXT:
Hybrid Control System / Description And Operation
The Hybrid Electric Vehicle (HEV) uses hybrid power source (Engine, Electric
motor), so its fuel efficiency is relatively
high and exhaust emission is very small compared to the traditional vehicle
which uses only engine as power source. It
con
Hybrid Control System / Components And Components Location
HPCU (Hybrid Power Control Unit)
On-Board Charger (OBC)
Charge Port
Power Cable (HPCU↔HSG,Electronic A/C
Compressor)
Power Cable (HPCU↔Main High Voltage Battery System)
Power Cable (Main High Voltage Battery System â
Hybrid Power Control Unit (HPCU) connector and high voltage cable
Hybrid Power Control Unit (HPCU) terminal And Input/Output signal
HPCU Terminal Function
Connector (C133-S) (94Pin) : HPCU signal input and control
High Voltage Cable (C133-P) (2 Pin) : HPCU↔Power Relay Assembly
SEE MORE:
Detecting sensor
Front view camera
Front radar
Front corner radar (if equipped)
Rear corner radar (if equipped)
Refer to the picture above for the
detailed location of the detecting sensors.
CAUTION
Take the following precautions to maintain
o
Brake Line
Brake Line Components and components location
Removal
Disconnect the brake fluid level switch connector, and remove the
reservoir cap.
Remove the brake fluid from the master cylinder reservoir with a
syringe.
Warning
Do not spill
Categories
- Home
- KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual
- Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual
- Contact Us
